for secure data recovery supports the creation and further recovery from backup media. How to make a vintage radio iPod - that works! What you needįind your radio.Ĭontent-aware analysis obtains information from the disk surface and not just the file system, allowing the product to successfully recover documents other tools cannot even notice. It might be helpful to bring your ipod with you, for sizing purposes. I got mine at a thrift store, but they can easily be found at swap meets and yard sales. This step is the most fun! keep your eyes out for other cool craft projects while you’re there. My radio was held together with four phillips-head screws. After removing them, the case was conveniently held together by plastic tabs that were already built in. This made my life much easier, but it isn’t necessary–If your radio is held together only by screws, you’ll have to find a way of securing it. Small hinges and hooks can be found at any hardware store. I’d originally planned on hooking the ipod directly into the speaker, but had overestimated the depth of the case–the ipod wouldn’t fit with the speaker left intact. If your radio does fit, wiring the ipod to a speaker is fairly simple. If you’re comfortable stripping wires you can probably figure out how to cut up an old pair of headphones and make a speaker connection. If not, it’s probably best you don’t try. My radio had a piece of plastic that blocked the ipod. I used needle nose pliers to snap it out. Once you have enough room for the ipod:įoam it up. The foam I used was left over from an air conditioner install. It has adhesive on one side, and is perfect for the job. Any soft foam will work, though–break out the glue gun.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |